UgCS mission planning software stuck on 99% upload

[Caver Zach]

My company has been trying to fly a magnetometer payload using a DJI M300 RTK. We have been suggested to use the UgCS mission planning software, but we have issues with the mission uploads getting stuck at 99%. We were not having this issue for some time, then it started happening. We have tried a hard reset of the DJI controller and drone firmware. Has anyone else had this issue or does anyone have any suggestions? Thank you for any advice you might have to offer.

 

[Norstar]

I am assuming you have the latest UGCS version. Check your waypoints, sometimes if there is a couple that are too close with the adaptive turn on and a low altitude it will not load. I did some low flying, under powerlines, and with a combination of the low altitude, adaptive turn, and too close waypoints I was unable to load it. After I went through and cleaned up the mission it loaded. Hopefully this helps.